Why Roof Leaks Around Skylights and Chimneys Usually Point to Step Flashing—Not the Glass
When a brown water ring blooms across a ceiling beside a skylight or along the drywall framing a fireplace hearth, most homeowners immediately blame the skylight glass or cracked chimney mortar. That reaction makes intuitive sense—a pane of glass sitting in the middle of a roof looks vulnerable, and aging brickwork naturally draws scrutiny.
How Step Flashing Protects Roof Penetrations
Why Step Flashing Fails Long Before Skylight Glass
Relying on Roof Cement Instead of Proper Metal Layering
Reusing Old Flashing During a Roof Replacement
Missing Kickout Flashing at Bottom Corners
Ice Dams and Debris Buildup Along Curb Sides
What About the Upper Edge of a Chimney or Skylight?
Clues That Point to Flashing Rather Than Glass Failure
-
Leaks during wind-driven rain: If water appears only when rain blows from a specific direction—rather than during gentle, vertical showers—wind is likely driving water up under loose step flashing or unsealed counterflashing.
-
Staining on the drywall shaft walls: Moisture discoloring the painted drywall sides of a skylight tunnel—especially near the corners—almost always traces back to curb step flashing or apron flashing rather than the glass seal above.
-
Dampness near the bottom edge of the frame: When condensation forms on cold interior glass during winter, droplets run down the pane and collect cleanly along the bottom sill; intermittent staining higher up the framing points to exterior flashing intrusion.
-
Peeling paint or efflorescence beside an interior chimney chase: White chalky mineral deposits on interior brick or damp drywall flanking a fireplace usually indicate failed step flashing, missing counterflashing, or an absent chimney cricket.
Comments are closed.